pkgbase = klipper-git
	pkgdesc = 3D printer firmware with motion planning on the host
	pkgver = r3853.338bc82d0
	pkgrel = 1
	url = https://github.com/KevinOConnor/klipper
	arch = x86_64
	arch = i686
	arch = arm
	arch = armv6h
	arch = armv7h
	arch = aarch64
	license = GPL3
	makedepends = git
	depends = python2-cffi
	depends = python2-pyserial
	depends = python2-greenlet
	depends = python2-jinja
	depends = python2-can
	depends = libusb
	optdepends = ncurses: for choosing compilation config
	optdepends = avrdude: for flashing firmware on AVR MCU
	optdepends = stm32flash: for flashing firmware on STM MCU
	optdepends = avr-gcc: for AVR MCU firmware compilation
	optdepends = avr-binutils: for AVR MCU firmware compilation
	optdepends = avr-libc: for AVR MCU firmware compilation
	optdepends = python2-numpy: for resonance measurement
	optdepends = python2-matplotlib: for resonance measurement
	provides = klipper
	conflicts = klipper
	source = git+https://github.com/KevinOConnor/klipper#branch=master
	source = klipper.service
	source = sysusers.conf
	source = tmpfiles.conf
	md5sums = SKIP
	md5sums = ab5efd8e525d971b482a0fee94a7e7ff
	md5sums = 61912d101dc7c68c7314882b80621454
	md5sums = dd799b9d55045d950d407740d4a9a5c5
	optdepends_x86_64 = arm-none-eabi-gcc: for ARM MCU firmware compilation
	optdepends_x86_64 = arm-none-eabi-binutils
	optdepends_x86_64 = arm-none-eabi-newlib: for ARM MCU firmware compilation

pkgname = klipper-git